www.icenginc.com

	Home
	Services
	.: Printed circuit boards
	.: Reliablity testing
	.: ESD & latch-up testing
	.: Failure analysis
	Equipment
	.: Equipment one
	.: Equipment two
	.: Equipment three
	.: Equipment four
	Quality
	Employment
	News
	Our Location
	Contact
	Site Map

INNOVATIVE CIRCUITS ENGINEERING, INC.
is committed to providing the highest Quality Test Products and Services to its customers and continually improving the effectiveness of its Quality Management System

Latch-Up Testing Request Form:

To receive FREE Quotation for Latch-Up Testing Service, please using the online form below.
To help us better serve you, please provide a complete your requests of this Latch-up Testing Request. A Sales Technical will respond to you by email or phone within 24-hours.

Company*:

Contact name*:

Telephone*:

Fax*:

E-mail address*:

P.O. Number:

Number of units to test*:

Part Number:

Pkg. Type:

Requested turn time: Standard Expedite

PLEASE PROVIDE THE FOLLOWING FOR THE DEVICE

:: Data sheet
:: Extra units for set up

Are vectors required? Yes No If yes, please attach vector pattern .

Temperature at which devices should be tested ? Room Ambient and/or Maximum operating Temperature of

^oC

Negative Current Latch-up:

1. Voltage to which device should be powered

V (Vccq)

2. Please provide a list of input pins with the state (High or Low) they should be set to.

3. Does the device require preconditioning, for example resetting after power-up?

Yes No

If YES, describe in detail how the preconditioning should be performed.

4. What value of Icc, will be obtained if the device is setup correctly? mA (I nom)

5. What value of Icc will be defined as latch-up mA

6. What value should VccQ be raised to during test? (Vtest)

7. The starting trigger current required is mA, incrementing in mA steps to a maximum current of mA. The trigger voltage should be limited to V. The duration of the trigger voltage should be ms. The wait time before Icc will be measured is ms

Positive Current Latch-up:
Complete Only if conditions are different to Negative Current Latch-up

1. Voltage to which device should be powered V (Vccq)

2. Please provide a list of input pins with the state (High or Low) they should be set to

3. Does the device require preconditioning, for example after power-up? Yes No
If YES, please describe in detail how the preconditioning should be performed.

4. What value of Icc, will be obtained if the device is setup correctly? mA (I nom)

5. What value of Icc will be defined as latch-up mA.

6. What value should VccQ be raised to during test? (Vtest)

Supply Over-Voltage Test:

1. Voltage to which device should be powered V (Vccq).

2. Please provide a list of input pins with the state (High or Low) they should be set to

3. Does the device require preconditioning, for example after power-up? Yes No
If YES, please describe in detail how the preconditioning should be performed.

4. The starting trigger current required is V, incrementing in V steps to a maximum voltage V. The trigger current should be limited to mA. The duration of the trigger voltage should be ms. The wait time before Icc will be measured is ms.

Additional Information:

Forward email for you:

Yes No